Used Shacman M3000S 460HP 6x4 Tractor

Nov 15, 2026 Leave a message

Ava Garcia
Ava Garcia
Ava is a market analyst at Liangshan Guanyue Auto Trading Co., Ltd. She studies the market trends of pre - owned commercial vehicles, providing valuable insights for the company's business decisions.

A 2024 Tractor With 290,000 km on the Clock - and Why That Figure Is the Story

Euro 6 Shacman M3000S joins export stock in Jining, raising the question buyers in West Africa keep asking: is a newer year worth the fuel headache?

JINING, Shandong, 15 November 2026 - A 2024 Shacman M3000S tractor unit has entered export stock in Jining with 290,000 km showing on the odometer, a figure that works out to roughly 145,000 km a year since it left the line.

The unit is 6x4 with left-hand drive, powered by a Weichai engine rated 460 hp, paired with a manual gearbox carrying a factory retarder and a 3.7 rear axle ratio. Paint is original red. The truck spent its working life on domestic line haul rather than in short-cycle site work, which accounts for the mileage being high while panel condition remains clean.

The Euro 6 question

What makes this unit worth writing about is not the odometer. It is the emission standard. A 2024 build means Euro 6, and Euro 6 means low-sulphur diesel and a functioning AdBlue system - two things not guaranteed at every pump in the markets where Chinese used trucks sell best.

"We put that in the first paragraph of the listing now, not the last," said [Sales Manager Name], who handles export enquiries for [Company Name]. "Two years ago buyers asked for the newest year they could get. Now the ones who have already imported a Euro 6 unit come back and ask for Euro 3. They worked out that a truck sitting in the workshop is more expensive than an older truck that runs."

The company's answer is to quote alternatives rather than talk a buyer into the wrong unit. Euro 3 and Euro 5 stock is held alongside, at lower cost, for markets where fuel sulphur remains high.

Gearing points to a specific buyer

A 3.7 final drive is a highway ratio: low cruise rpm, better fuel figures, and less pulling power on a loaded climb than the 4.11 or 4.77 alternatives. That narrows the fit to port-to-inland runs, trunk routes and cross-border long haul. Buyers working mine haulage or mountain roads are advised against the unit.

Retarder fitment on a truck at this mileage is a practical detail rather than a selling point. At 290,000 km the service brakes are well past their best, and the retarder absorbs most of the load on long descents.

What the buyer receives

Tread depth is measured on every tyre and photographed against a wheel position number, with the readings issued alongside the truck. Third-party inspection is available at the buyer's cost with the buyer appointing the inspector. Export documentation is prepared per unit, and photographs covering each angle are provided before loading.

The stated mileage is presented as the seller's figure, supported by the service record and open to verification during inspection rather than asserted as fact.