2020 Shacman X3000 440HP 4x2 Tractor

Nov 17, 2026 Leave a message

Ava Garcia
Ava Garcia
Ava is a market analyst at Liangshan Guanyue Auto Trading Co., Ltd. She studies the market trends of pre - owned commercial vehicles, providing valuable insights for the company's business decisions.

72,000 RMB and 385,000 km: The Case for Buying the Cheapest Tractor That Still Runs
A 2020 Shacman X3000 enters export stock in Jining. It will not win a beauty contest. That is what makes it interesting.
JINING, Shandong, 17 November 2026 - A 2020 Shacman X3000 tractor has been listed from export stock in Jining at 72,000 RMB, roughly 9,900 USD at current rates, with 385,000 km showing on the odometer and a stated guarantee that the figure is genuine.
The unit is a 4x2 with left-hand drive, powered by a Cummins engine rated 440 hp, mated to a manual gearbox with an output-shaft retarder and a 3.7 rear axle ratio. Emission standard is Euro 5, or National V in Chinese terms.
A price segment nobody writes about
Export coverage tends to focus on low-mileage Euro 6 stock and near-new fleet releases. The segment that actually moves volume sits below that: ten-year-old-to-recent tractors with six figures on the clock, sold on price to buyers who intend to run them into the ground and rebuild them once.
72,000 RMB is the entry point for a Cummins-powered tractor. It is the figure that lets a buyer with a two-truck operation enter the market at all.
"What the buyer is really purchasing is a rebuildable engine and a straight frame," said [Sales Manager Name] of [Company Name]. "The cab will be worn and the paint will be tired. If that bothers him, he should spend three times as much. If it does not, this truck will earn money from the first week."
The mileage question, answered rather than avoided
385,000 km represents roughly 5,500 engine hours at typical average speeds, and engine hours are what wear a diesel. The Cummins in this unit is past its first life. Compression readings are being issued with the inspection sheet, and a buyer planning five years of heavy work should carry an overhaul in the budget. A buyer running lighter loads on paved roads may never need one.
Cab condition is reported as consistent with the odometer: compressed seat foam, polished steering wheel rim, hinges adjusted at some point in the truck's life.
4x2 limits stated plainly
Single drive axle restricts the duty cycle. Container shuttles, port-to-warehouse runs, two-axle trailer work and regional hauling on sealed roads are within scope. Sixty-tonne gross combinations, mine access roads and soft ground under load are not. The company is directing those enquiries to 6x4 stock rather than selling the cheaper unit into the wrong job.
The ratio and the retarder
A 3.7 final drive keeps cruise rpm low and fuel consumption in check. The retarder on the output shaft takes load off service brakes that have already covered a lot of distance - the practical reason a high-mileage tractor with one fitted is a better buy than the same truck without.
Euro 5 as the middle ground
Euro 5 requires low-sulphur diesel but carries no AdBlue or DPF obligation. For import markets where fuel quality varies between suppliers, that makes it more forgiving than a Euro 6 unit and cleaner than a Euro 3. Fuel that would put a Euro 6 truck into derate inside a week will run in this engine without drama.
Pricing and terms
The 72,000 RMB figure is ex-works and tracks the exchange rate, confirmed in writing at order. Tyres are measured at each wheel position and photographed, with readings issued before payment. Third-party inspection is available at the buyer's cost, with the buyer appointing the inspector.