2020 Shacman X3000, 440 hp, 4x2 - priced for work, not for photographs
A 2020 truck with 385,000 km on it does not sell on condition. It sells on price, engine, and how much life is left in the parts that matter. This unit is 72,000 RMB, which is the whole argument.

385,000 km. Let's deal with that first
Nearly four hundred thousand kilometres is a lot. It is also the reason the truck costs what it costs. The engine has run roughly 5,500 hours to cover that distance, and hours are what wear a diesel, not kilometres alone.
What that means in practice: the Cummins is past its first life. Compression should be checked before you commit, and a buyer planning five more years of heavy work should budget for an eventual in-frame overhaul. A buyer running lighter loads on decent roads may never need it. We will give you the compression readings and let you decide, rather than describing the engine as "in good condition" and leaving it there.
Cab wear matches the odometer. Seat foam is compressed, the steering wheel rim is polished, the door hinges have been adjusted at some point. Nothing broken, nothing hidden.
Cummins 440, and the rebuild question
Cummins 440 hp. The reason this matters on a 2020 Shacman is parts and rebuildability. Cummins blocks in this class get rebored and rebuilt in workshops from Lagos to Almaty, and the kits are available. An engine that can be brought back is worth more than a marginally better engine that cannot.

Injectors and the fuel pump are the two items to check on any high-mileage Cummins. Both were tested on this unit and the results are in the inspection sheet.
4x2 - who this truck is for, and who should skip it
Single drive axle. That sets the limits clearly.
It suits container shuttles, port-to-warehouse runs, two-axle trailer work and regional hauling on paved roads. It is lighter than a 6x4, it burns less fuel doing the same job empty, and it costs less to buy and to tyre.
It does not suit 60-tonne gross combinations, mine access roads or anything involving soft ground under load. A 4x2 will get stuck where a 6x4 walks through, and no amount of horsepower fixes traction. If that is your work, buy a 6x4 and pay more.
3.7 with a retarder
Rear axle ratio is 3.7 - a highway gear, low cruise rpm, and fuel figures to match. The gearbox is manual with a retarder on the output shaft. On a truck at this mileage the service brakes have already done a lot of work, and the retarder is what keeps them from being the next thing you replace.
Euro 5, and the fuel it tolerates
Euro 5 needs low-sulphur diesel but does not carry the AdBlue and DPF burden of a Euro 6. For markets where fuel quality is inconsistent, this is the practical middle ground: cleaner than a Euro 3, far more forgiving than a Euro 6. It will run on fuel that would put a Euro 6 truck into derate within a week.
What 72,000 RMB buys, and what it does not
72,000 RMB, roughly 9,900 USD at the current rate. That figure is ex-works and moves with the exchange rate - confirm it in writing when you order.
It buys the truck, the export documents and the inspection sheet. It does not buy new tyres, a fresh paint job or a warranty. Tyres are measured per wheel and photographed, and you see the numbers before you pay.
Cab
Left-hand drive, standard X3000 cab. Air conditioning works. Instruments, switches and locks tested. The interior is honest for the mileage - worn where a 385,000 km truck is worn, intact where it should be.
Hot Tags: 2020 shacman x3000 440hp 4x2 tractor, China 2020 shacman x3000 440hp 4x2 tractor manufacturers, suppliers, factory, Auman Tractor, compact field tractor, Delong Tractor, Howo Tractor, infrastructure farming machinery, transport utility truck






